Wiznet WIZ-Embedded WebServer Guide de l'utilisateur télécharger pdf (Page 32)

WIZnet Open Hardware Platform

WIZnet Shield for Arduino

WIZnet WizFi Shield

WIZnet WizFi shield provides WiFi connectivity to your Arduino-based project. It is a

drop-in and plug-and play solution to provide 802.11 b/g WiFi connectivity to your

Arduino Diecimila, Duemilanove and Uno

• Use SPI BUS for host communication

• Simple control commands like AT command

• Antenna : on-board chip antenna type or cable via U. FL connector (optional)

• Indication LEDs

- Power : indicates that the board and shield are powered

- W_COM : indicates the presence of a Wifi network link

- S_CON : indicates the presence of a Serial Link

- S_RXD : flashes when the shield receives data from Arduino

- 2 Debug LED

WIZnet Ethernet Shield

WIZnet Ethernet Shield allows an Arduino board to connect to the Internet. WIZnet

W5200 provides a hardwired TCP/IP protocol stack enabling your application to

communicate by TCP or UDP.

• Micro-SD card slot for storing data

• On board W5200

• 10/100 Mbps, Full/Half Auto Negotiation, Auto MDI/MDIX

• Indication LEDs

- Power : indicates that the board and shield are powered

- LINK : indicates the presence of a network link

- Duplex : Indicates the presence of a network link

- Speed : indicates the presence of a 100 Mbps network connection

- 2 Debug LED

WIZnet opens all hardware & software source materials of WIZnet WiFi & Ethernet shields. (not produce

and supply the products). Please contact to [email protected] for more detail.

1 2 ... 27 28 29 30 31 32 33 34 35 36

Pas de commentaire

Wiznet WIZ-Embedded WebServer Guide de l'utilisateur Page 32